KRHÜNER 60025 Manual De Instrucciones página 9

switches the unit to standby after the preset time. Each time the button is pressed, the
hours will increase one by one and the time indicator will light on the screen. To cancel
the timer, simply press the button until the indicator is off.
5. Swing: press the "Swing" button, and the swing indicator will be on.The air control
blades are activated, which disperse the outflow of air to the left and right. Press the
button again to stop the oscillation. The control blades are responsible for directing the
airflow up and down, and must be set manually.
6. Cooler: to activate the air cooler function, please press the "Cooler" button. The water
pump will take the water from the tank and pour it onto the cooling pad. The cooling
pad absorbs the heat of the water and the evaporated air is blown out by the help of the
fan. The cool breeze blown by the cooler drops the temperature and creates a relaxing
cooling effect.
Caution: If the water level is low or there is no water in the tank, the cooler indicator will
be flashing and there will be sounding warning beeps when you press the "Cooler" but-
ton. Check the water level, after adding water, press again the "Cooler" button to activate
the "Cooler" function. Replace the stale water with fresh water. It is recommended to
replace the water in the tank at least once in a week.
7. Remote control: uses a CR2025 button cell. Before using, please pull out the card
which is inserted at the bottom of the remote control.
OPERATING THE WATER TANK
Check the level of the water in the tank frequently. Be sure that water level is not below
the 'MIN' marking which is located on the water tank.
Before refilling water, turn your unit to 'the "Off" position by pressing the switch located
on the back panel and unplug the power cord.
USING THE ICE BOXES
In order to increase the cooling effect of your fan, you can use the ice boxes which are
supplied with the unit. Before using, place them into the freezing compartment of your
refrigerator for a few hours. Then place them into the large section of the tank and add
water to the 'MAX' level. Using the ice boxes will drop the temperature of the air flow
which will create a more effective cooling effect.