Mark BEAM LED 150 Manual Del Usuario página 6

If a DMX512 splitter is used, follow these instructions:
At first, connect the DMX512 terminal from the controller to the DMX input in the first device. Use
another cable to connect the DMX output to the DMX input of the second device, and so on. To prevent
system errors, the last device in a DMX chain needs to be equipped with a terminating resistor (120
ohm, 1/4 Watt).
BEAM LED 150 has on its front panel a touch display in order to navigate through several menus and
select functions, settings or information. Before turning on the device, make sure the PAN and TILT
locks ARE UNLOCKED. Connect the device to an adequate power supply point and the DMX signal from
a console.
To connect more than one unit in parallel, please, follow this draw. The output of the first unit must
provide to the next DMX input of the signal, this way it is possible to send the signal to all the devices
in the chain.
5