Publicidad
Idiomas disponibles
Idiomas disponibles
4. Reinstall the oil filler cap/dipstick.
OIL FILLER CAP/DIPSTICK
OIL FILL HOLE
(bottom edge)
Running the engine with a low oil level can cause engine damage.
This type of damage is not covered by the Distributor's Limited Warranty.
The Oil Alert system (applicable types) will automatically stop the engine
before the oil level falls below the safe limit. However, to avoid the
inconvenience of an unexpected shutdown, always check the engine oil
level before startup.
Oil Change
Drain the used oil when the engine is warm. Warm oil drains quickly and
completely.
1. Place a suitable container below the engine to catch the used oil,
then remove the oil filler cap/dipstick, oil drain plug and sealing
washer.
2. Allow the used oil to drain completely, then reinstall the oil drain
plug and a new sealing washer, and tighten the oil drain plug
securely.
TORQUE: 18 N∙m (13 lbf∙ft, 1.8 kgf∙m)
Please dispose of used motor oil in a manner that is compatible with the
environment. We suggest you take used oil in a sealed container to your
local recycling center or service station for reclamation. Do not throw it
in the trash, pour it on the ground, or pour it down a drain.
3. With the engine in a level position, fill with the recommended oil (see
page 8) to the upper limit mark (bottom edge of the oil fill hole) on
the dipstick.
Engine oil capacity:
GX160: 0.58 L (19 US oz, 0.51 lmp qt)
GX200: 0.6 L (20 US qt, 0.53 lmp qt)
Running the engine with a low oil level can cause engine damage. This
type of damage is not covered by the Distributor's Limited Warranty.
The Oil Alert system (applicable types) will automatically stop the
engine before the oil level falls below the safe limit.
However, to avoid the inconvenience of an unexpected shutdown, fill
to the upper limit, and check the oil level regularly.
4. Install the oil filler cap/dipstick and tighten securely.
UPPER LIMIT
LOWER LIMIT
Wash your hands with soap and water after handling used oil.
REDUCTION CASE OIL (applicable types)
Recommended Oil
Use the same oil that is recommended for the engine (see page 8).
Oil Level Check
Check the reduction case oil level with the engine stopped and in a level
position.
2 : 1 Reduction Case With Centrifugal Clutch
1. Remove the oil filler cap/dipstick and wipe it clean.
2. Insert and remove the oil filler cap/dipstick without screwing it into
the filler hole. Check the oil level shown on the oil filler cap/dipstick.
3. If the oil level is low, add the recommended oil to reach the upper
limit mark on the dipstick.
4. Screw in the oil filler cap/dipstick and tighten securely.
UPPER
LIMIT
6 : 1 Reduction Case
1. Remove the oil-level-check bolt
and washer, and see whether the
oil level is at the edge of the bolt
hole.
2. If the oil level is below the check
bolt hole, remove the filler bolt and
washer. Add oil until it starts to
flow out the check bolt hole with
the recommended oil (see page 8).
3. Install the oil-level-check bolt, filler
bolt and new washers. Tighten
them securely.
ENGLISH
SEALING WASHER (Replace)
DRAIN PLUG
OIL FILLER CAP/
DIPSTICK
OIL LEVEL
LOWER LIMIT
OIL FILLER CAP/DIPSTICK
FILLER BOLT
OIL LEVEL
OIL-LEVEL-CHECK BOLT
9
Publicidad
