Balluff BIS V-830-3-011-B-000 Instrucciones Breves página 8

BIS V-830-3-011-B-00_
Mobile RFID devices
Construction and function of basic device (continued)
Code scanner (only for BIS V-830-3-011-B-001 and
BIS V-830-3-011-B-002)
With the 2D short-range scanner SE4770 1D and 2D
barcodes can be read at a reading distance up to
approximately 90 cm.
The scanner is located at the top in the housing under the
disk of the device, buttons for operation are the side of the
housing.
Camera (only for BIS V-830-3-011-B-001 and
BIS V-830-3-011-B-002)
There is an auto-focus camera (5 megapixel) on the back
of the basic device.
RFID/NFC reader (only for BIS V-830-3-011-B-002)
The device has a RFID/NFC reader PN7150 with
integrated firmware, which supports the following
operating modes or protocols:
– NFC-IP modes
Reader NFC Forum Tag Type 1 to 5,
P2P active initiator and target, P2P passive initiator and
target, Reader/Writer mode, Peer to Peer mode and
Card emulation.
– Reader (PCD-VCD):
ISO/IEC 14443A/B, ISO/IEC15693,
MIFARE Classic/DESFire, Sony FeliCa.
– CARD (PICC):
T4T-ISO/IEC14443A, ISO/IEC14443B,
NFC FORUM T3T.
The read range of the reader is in the front section of the
device (see image).
The range is dependent on position, size and technology
of the data carrier and is from a few millimeters to a few
centimeters.
WLAN/BT-compatible near field communication
WLAN in accordance with IEEE 802.11ac/a/b/g/n incl.
802.11d, 802.11h, 802.11e, 802.11i, 802.11w, as well as
BT-compatible near field communication in accordance
with BT standard V5.0, are integrated in the basic device.
WLAN Security1: WEP, WPA, IEEE802.11i (Personal and
Enterprise), WPA2, AES, TKIP, WPA2-PSK, 802.1x:
authentication, 802.1x EAP, TLS, TTLS, PEAP, SIM, AKA,
AKA-PRIME, PMK Caching
3 english
Read range
Construction and function of charging
and transmission box
The basic device and a spare battery (accessories) can be
charged in the charging and transmission box.
Station for basic device
Connections
USB RJ45
Connec-
tion
USB The USB port type A is the USB host
interface.
The identification of the connected USB
devices is realized by the USB host
adapter in the basic device.
RJ45 The RJ45 socket is the Ethernet interface
(10/100 Mbit).
The network communication is realized
via the Ethernet interface in the basic
device.
DC Connection of the power supply unit
(power supply)
Display elements
LED Speed CHARGE
Battery compartment
DC
Function
LED CHARGE