Publicidad
Idiomas disponibles
Idiomas disponibles
Crosscut Paper Shredder
Operating Instructions
Installation
Operation
Warning
Troubleshooting
Maintenance
Limited Product Warranty
Déchiqueteuse à coupe croisée
Manuel de fonctionnement
Installation
Fonctionnement
Avertissement
Dépannage des déchiquteuses
Entretien
Garantie limitée du produit
Máquina destructora de
documentos de corte transversal
Instrucciones para operar
Instalaciones
Operación
Avertencia
Solucionar Problemas de la
Máquina Trituradora
Mantenimiento
Garantía Limitada del Producto
*
ONE FOLDED SHEET OF PAPER EQUATES TO 2 SHEETS OF PAPER
Heavier paper, humidity or other than rate voltage may reduce capacity.
*
UNE FEUILLE DE PAPIER PLIÉE ÉQUIVAUT À DEUX FEUILLES
Le papier plus épais, l'humidité et une tension différente de la tension nominale peuvent réduire la capacité.
*
UNA HOJA DE PAPEL DOBLADA EQUIVALE A 2 HOJAS DE PAPEL
Si el papel es más pesado, si está húmedo a las tensión es otra, la capacidad puede disminuir.
2
12 sheets of
Sheet Capacity
20lb. bond paper
7/32" x 2 5/32" pieces
Paper Shred Size
0.56 cm x 5.5 cm pieces
Paper Entry Width
8.7" / 22.0 cm
Credit Card & CD Capacity
1 at a time
Voltage
120V~60Hz 3.0A
Capacité de passage
12 feuilles de papier
à la fois
bond de 75g/m2 (20lb.)
en morceaux de 7/32" x 2 5/32"
Dimensions des déchets
en morceaux de 0.56 cm x 5.5 cm
Largeur d'entrée
22,0 cm (8,7 po)
Capacité de CD et
les introduire un par un
les cartes de crédit
Tension
120V~60Hz 3.0A
Capacidad de
12 hojas de papel
destruccióna la vez
de cartes de 20 libras
en pedazos de 7/32" x 2 5/32"
Tomaño de corte
en pedazos de 0.56 cm x 5.5 cm
Apertura de la alimentación
8.7" / 22.0 cm
Capacidad de CDs y
introdúzcalos en la ranura
tarjetas de crédito
uno por uno
Voltaje
120V~60Hz 3.0A
INSTALLATION :
*
*
Mount the shredder securely to the rim of the waste basket. (FIGURE 1)
A socket-outlet should be near the equipment and be easily accessible.
Connect the power cord to any standard 120 volt AC outlet.
ATTENTION:
This model includes a built-in safety interlock mechanism, which requires the
shredder to be correctly mounted on to the included wastebasket. Located on the
back center of the shredder, next to the power cord, there is a curved flap-like
*
shape that must FIT OVER THE OUTSIDE matching ridge of the wastebasket.
(FIGURE #1) THE SHREDDER WILL NOT OPERATE UNLESS IT IS
PROPERLY MOUNTED AS PICTURED!
It is not designed to operate with any other wastebaskets. An activation switch located on the head unit
automatically shuts off the shredder when it is lifted or removed. The supplied wastebasket activates this
switch, which allows the shredder to be operable. Lining the wastebasket with a plastic bag will interfere
and may keep the shredder from functioning.
Caution: Crosscut shredders have very sharp exposed blades on the underside.
Use care when mounting the shredder on the wastebasket.
FIGURE 1
3
Publicidad
