Waterdrop WD-FC-01 Manual Del Usuario página 5

After installation, open faucet. Switch the Lever (H) to"tap"position, and unfiltered
water will run through.
NOTE:
1. Before first use, run cold water for 1 minute in"pure"position. Do not run hot
water above 122°F/50 through the filter. During flush, it is normal to see cloudy
water and hear the sound of water pushing air out of the filter cartridge.
2. Check for leaks. If there is any leak, please refer to FAQ.
3. Please switch the lever slowly to avoid damage to mounting base.
Unscrew the Filter Top Cover(B) from the Filter Base (C). Take out
the filter from package and remove the protective film. Insert the
filter into Filter Base (C). Twist the Filter Top Cover(B) back to Filter
Base (C) securely.
NOTE: Please insert the filter firmly until it sits.
Align the slot of Filter Base(C) with the slot of Mounting Base(G).
Insert the Filter Base (C) into the Mounting Base (G) and rotate
90° upward.
How to Use
Tap Water Pure Water