Magmaweld COMPACT EXPERT Serie Manual Del Usuario página 38

38 Annex
ANNEX
EN
5.1 Fine Settings in the Wire Feed Unit
As long as the button is held pressed, the wire is fed and the gas valve does not operate. You can use this
1-Free Wire Feed Button
button to feed the wire into the torch.
When the free gas button is pressed, the gas will come for 30 seconds and if the free gas button is not pressed
2-Free Gas Button
again within 30 seconds, the gas flow will stop after 30 seconds. If the free gas button is pressed again within
30 seconds, the gas flow will stop as soon as it is pressed. With the free gas button, gas flow is enabled and
wire feed does not run. You can use this button to change the gas in the system after a gas change.
USER MANUAL
COMPACT EXPERT SERIES
www.magmaweld.com