Publicidad
Idiomas disponibles
Idiomas disponibles
CP 80142
OPERATING YOUR FAN
1. Open the box and get the ceiling fan.
2. Mark in the ceiling the two points where you're going to make the holes with the help of the ceiling
support. Then, make the holes and screw the support to the ceiling.
3. Insert the hanger pipe through the upper canopy and join it together with the help of the support.
In order to do it, introduce the motor's wires through the hanger pipe. Raise the fan and fit the
pipe's head to the upper canopy. Make it coincide the mark in the head with the clip in the canopy.
4. Mount the remote control receiver.
5. Connect the fan's pins as indicated and connect the wires from the ceiling to the circuit board in the
canopy. Make sure that the connections are done properly.
N – Neutral
6. Screw the upper canopy to the ceiling with the help of the four correspondent screws.
7. Attach the blade brackets to the fan blades, tightening the screws, the flat washers, the lock washers
and the nuts.
8. Mount the fan blades to the motor, tightening all screws and lock washers.
9. Put in the bulbs (sold separately) E27
10. Put the lampshades on their support and carefully screw back the thumb screws to fix the
lampshade. Be careful not to over tighten the thumb screws, because the lampshades might break.
L – Live
̶ Earth
2X60W
11
Publicidad
