K-Tool KTI-XD63136 Manual Del Propietário página 2

WARNING INFORMATION
This is the safety alert symbol. It is used to alert you to
potential personal injury hazards. Obey all safety messages
that follow this symbol to avoid possible injury or death.
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility
of the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels
are lost or not legible, contact K-Tool International for replacements. If the operator is not fluent in English, the product and safety
instructions shall be read to and discussed with the operator in the operator's native language by the purchaser/owner or his
designee, making sure that the operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of portable automotive lifting devices and applicable attachments, adapters, and accessories are subject to certain hazards
that cannot be prevented by mechanical means, but only by the exercise of intelligence, care, and common sense. It is therefore
essential to have owners and personnel involved in the use and operation of the equipment who are careful, competent, trained,
and qualified in the safe operation of the equipment and its proper use. Examples of hazards are dropping, tipping or slipping of
loads caused primarily by improperly secured loads, overloading, off-centered loads, use on other than hard level surfaces, and
using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study carefully, and understand the operating manual packed with this dolly before operating.
• User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.
• Read the appropriate vehicle service manual for instructions and procedures on fuel tank removal and installation.
• Always have an approved fire extinguisher accessible for immediate use. Never use this device near people smoking,
open flames, heat sources or sparks.
• Consult the device's owner's manual for instructions on grounding requirements for metal tanks before performing any work.
• Always drain the fuel tank into a grounded storage container before removal or installation.
• Make sure the fuel tank is centered and balanced on the adapter and jack before removal or installation.
• Always secure the fuel tank to this device with the tie-down straps provided before moving the fuel tank.
• The fuel tank may only be transported when the jack has been retracted to its lowest position.
• Product is to be used only with compatible ASME PASE products.
• Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the
manufacturer's authorized representative.
• Failure to heed these warnings may result in personal injury, property damage, or both.
WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS
SITUATIONS could cause accidents resulting in serious or fatal personal injury and/or property damage.
KTI-XD63136
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
WARNING: Indicates a hazardous situation
WARNING
which, if not avoided, could result in death
or serious injury.
2 03/24/21