Descargar Imprimir esta página

Beurer FM 60 Instrucciones De Uso página 14

Ocultar thumbs Ver también para FM 60:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
6. START-UP
• Remove the packaging.
• Check the device, power supply and cables for damage.
• Connect the device to the mains power supply.
• Set the main switch to 1.
• Route the cable safely so that there is no risk of anyone tripping over it.
7. OPERATION
Remove your shoes before each use. When seated comfortably, place your feet on the massage heads.
Switch on the massager firstly at the main switch and then with the
function and the 2nd speed setting, press the on/off button again. Press on/off again to switch off
the device.
For an optimum massage position, the rear feet can be adjusted. Rotate the feet higher in a clockwise
direction or lower in an anti-clockwise direction.
The massage must be pleasant and relaxing at all times. Stop the massage or change your position or
the contact pressure if you find it is painful or unpleasant.
• Do not use the massage device for longer than 15 minutes. Otherwise, using the device for
longer can over-stimulate the muscles and cause tension instead of relaxation.
Massage of a specific point on the sole of the foot may influence the corresponding organ of
the body. However, we recommend studying relevant literature and asking your doctor before
using point reflex zone massage to achieve the desired effect.
8. CLEANING AND MAINTENANCE
Cleaning
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Clean the instrument with a slightly moistened cloth. You can also moisten the cloth with mild soap
suds to remove more stubborn dirt.
• Smaller stains can be removed using a cloth or moist sponge together with a little liquid detergent
for delicate fabrics if necessary. Do not use any cleaning agents containing solvents.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a
dry place without weighting it down.
button. To switch on the heat
14

Publicidad

loading