Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
FAULT
The program does not start.
Water remains inside the machine.
Machine stops during washing.
Shaking and bumping noises are
heard during a wash cycle.
Food waste partially left on the dishes.
There are whitish stains left on the
dishes.
Dishes do not dry.
44
POSSIBLE CAUSE
Your dishwasher is not plugged in.
Your dishwasher is not switched on.
Fuse blown.
Water inlet tap is closed.
Your dishwasher door is open.
Water inlet hose and machine filters
are clogged.
Water drain hose is clogged or
twisted.
The filters are clogged.
The program is not finished yet.
Power failure.
Water inlet failure.
The spray arm is hitting the dishes in
the lower basket.
Dishes placed incorrectly, sprayed
water not reaching affected dishes.
Dishes leaning against each another.
Not enough detergent used.
Wrong wash program selected.
Spray arms clogged with food waste.
Filters or water drain pump clogged or
filter misplaced.
Not enough detergent used.
Rinse-aid dosage and/or water
softener setting set too low.
High water hardness level.
Salt compartment cap not closed
properly.
Drying option is not selected.
Rinse-aid dosage set too low.
TROUBLESHOOTING
Plug your dishwasher in.
Switch your dishwasher on by
pressing the On/Off key.
Check your indoor fuses.
Turn on the water inlet tap.
Close the dishwasher door.
Check the water inlet hose and
machine filters and make sure they
are not clogged.
Check the drain hose, then either
clean or untwist it.
Clean the filters.
Wait until the program is finished.
Check mains power.
Check water tap.
Move or remove items blocking the
spray arm.
Do not overload baskets.
Place dishes as instructed in the
section on loading your dishwasher.
Use the correct amount of detergent,
as instructed in the program table.
Use the information in the program
table to select the most appropriate
program.
Clean the holes in the spray arms with
thin objects.
Check that the drain hose and filters
are correctly fitted.
Use the correct amount of detergent,
as instructed in the program table.
Increase rinse-aid and/or water
softener level.
Increase water softener level and add
salt.
Check that the salt compartment cap
is closed properly.
Select a program with a drying option.
Increase rinse-aid dosage setting.
Publicidad
