Jimmy F7 Manual Del Usuario página 6

Maintenance and Storage
Please make sure the button is in the Off position and
then unplug the socket during cleaning.
Please regularly use the towel, cotton bud or tooth brush
to clean the inlet and outlet.And Rotate down air inlet end
cap to clean the filter screen.
Please do not use nail or sharp articles to press and rub
the inlet and outlet to avoid products damage.
Please do not use alcohol, nail polish remover or
detergent to clean the products, otherwise, it will cause
failure, crack or colour fading.
8
Safety Notes
Please read this instruction manual carefully before use,
properly save and store it for future use.
Please use the voltage and electric current as described on
the rating label.
Please do not block the outlet and inlet, otherwise, it will
cause scald, electric shock or fire due to short circuit.
Please do not use the hair dryer when the hands are wet,
otherwise, it will cause electric shock and fire caused by
short circuit.
Please do not unplug the power plug when the hands are
wet, otherwise, it will cause electric shock and injury.
When the hair dryer is used in the bathroom, unplug it after
using, even though the hair dryer is powered off, it is still
dangerous when it is close to water.otherwise it might cause
accidents or damages.
Please do not use hair dryer next to bath tub, shower,
lavatory or other utensil etc.
Please do not use the products when the power line is
entangled, otherwise it will cause electric shock or fire due to
short circuit.
Please do not use the machine near to petroleum gas or
other inflammable (like propellant, paint thinner, spray etc.),
otherwise it will cause explosion.
Please do not leave the power on when the machine is not
used, otherwise it will cause fire due to short circuit.
Please do not entangle the power line around the main
machine, otherwise it will cause power cut and cause
electric shock or fire due to short circuit.
Please keep out reach of children and infants to avoid
electric shock and injury.
Please do not put the inlet downwards during working,
otherwise it will cause thermal fuse red and cause fire.
Please do not damage, refit, bend hardly, pull,twist the
power line, or put anything on the power cord , squeeze the
9