Jimmy F7 Manual Del Usuario página 8

Trouble Shooting
Please check the following issues before sending
to designated repair offices.
Failure 1: The motor is not working
Possible Cause 1: Not plugged in tightly.
Solution 1: Check whether power cord plugged in tightly.
Possible Cause 2: No power on the socket.
Solution 2: Check the socket.
Possible Cause 3: The on/off button is not pushed to
proper position.
Solution 3: Push on/off button to proper position.
Failure 2: Device does not work after turned on
Possible Cause 2: The on/off button has been pushed too
frequently, machine protection has been activated.
Solution 2: Turn off machine, wait for 2-3 seconds,
then turn on again.
Failure 3: Device power off suddenly
Possible Causes 1: Overheating protection system started.
Solution 1: Switch off and unplug the power cord, use it
after it cool down for few minutes.
Possible Causes 2: The air inlet was blocked by fluffy, hair,
etc, which lead to overheating protection system.
Solution 2: Switch off and unplug the power cord, use it after
cool down for few minutes.
Failure 4: Air volume is small
Possible cause 1: The inlet was blocked by fluffy, hair, etc.
Solution 1: Clean air outlet.
If fault remains after adopting the above solutions,
contact after sale service or local distributor immediately.
12
Product Specification
Technical Parameter
Model No
Rated Power Supply
Rated Power
Circuit Diagram
Slide switch Fuse
Resistance
220V-240V~
Capac-
50Hz
itor
Temperature
fuse
PTC
F7
220V-240V~50Hz
1600W
Negative ion Nano water
generator ion generator
Motor Control
Circuit
Recti-
fying
circuit
Heating Fuse
Control Circuit
NTC outlet
Heater
Bidirectional thyristor
High
speed
digital
motorr
Display
button
13