Replacing Carbon Brushes - Makita 3700B Manual De Instrucciones

1
2
3
4
When cutting, move the tool with the guide roller riding
the side of the workpiece.
1
Trimmer shoe (Optional accessory)
By attaching the trimmer shoe, you can obtain a right-
angle guide surface for the trimmer base guide. This
enables accurate chamfering and similar edge work.
Remove the trimmer guide from the tool. Install the trim-
mer shoe on the tool base with the adjusting screw and
the clamp screw (B). Loosen the clamp screw (B) and
adjust the distance between the bit and the trimmer shoe
by turning the adjusting screw (1 mm (3/64") per turn). At
the desired distance, tighten the clamp screw (B) to
secure the trimmer shoe in place. When cutting, feed the
tool in the direction of the arrow on the trimmer shoe.
1
2
004563
1. Clamp screw
(A)
2. Adjusting screw
3. Clamp screw
(B)
4. Trimmer guide
001998
1. Workpiece
2
2. Bit
3. Guide roller
3
007114
007115
1. Adjusting screw
3
2. Clamp screw
4
(B)
3. Guide holder
4. Clamp screw
(A)
5. Trimmer shoe
5
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.

Replacing carbon brushes

Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified in
this manual. The use of any other accessories or
attachments might present a risk of injury to per-
sons. Only use accessory or attachment for its
stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Straight & groove forming bits
• Edge forming bits
• Laminate trimming bits
7
001145
1. Limit mark
1
007116
1. Screwdriver
2. Brush holder
cap
1
2