Main Functions; Keypad Block; Pin Change; Reduced Opening - Manusa SMART Manual De Usuario

DTCXSL01EN - v1 - ENGLISH

5 - MAIN FUNCTIONS

5.1 - KEYPAD BLOCK

To avoid undesired manipulations, you may block the
selector keypad by simultaneously pressing the left and
right buttons for 2 seconds. Zone 5 of the display will show
a small lock sign
In this mode, if any button is pressed, the message KEY
BLOCK will show on the display.
To unblock the keypad, simultaneously press again the left
and right buttons for 2 seconds. Then enter the pin code to
unblock.

5.2 - PIN CHANGE

By default, the PIN is set to 1111. To modify it, access the
PIN menu (refer to section 6).

5.3 - REDUCED OPENING

In Automatic and Exit Only mode, the door may be
programmed to "Reduction opening" to reduce the opening
width of the door when the this opens.
To activate this mode, select option ACTIV REDUCT
OPEN in the ADJUSTMENTS menu.
5.4 - PEOPLE COUNTING SENSOR
Subject to model features, the Visio operator also has a
people counting sensor. If you wish to view the count on
the display, select menu DISPLAY, and then option VISITS.
If you wish to reset the people counting sensor to zero, you
must select the option RESET VISITS on the menu
COUNTERS (refer to section 6)
5.5 - DATE AND TIME MANAGEMENT
The SMART selector may show the current time in area 3
of the display.
To view the time, select option HOUR from the menu
DISPLAY. (refer to section 6)
To adjust the date and hour, go to options DATE and TIME
in the menu CLOCK.

5.6 - LANGUAGE

There are four languages available: Catalan, Spanish,
English and French. To change the language, select option
LANGUAGE from the menu ADJUSTMENTS.

5.7 - CONTRAST

To modify the contrast of the display, go to option
CONTRAST in the menu ADJUSTMENTS (refer to section
6).

6 - USER MENU

6.1 - MENU NAVIGATION

- Enter the user menu:
Press the central button for 1 second.
- Navigate through the different submenus:
To navigate through the different menu
options, press the left and right buttons.
To change the values of the configurable
options, press the left and right buttons of the
selector.
- To validate selection and set-up changes:
Press the central button to validate the set-up
changes and to validate the selection of an
option or submenu.
- To exit a menu or submenu:
Select the option EXIT and press the central
button to exit the current menu or submenu
and go to the main screen or the menu
immediately above.
NAVIGATION MAP:
USER MENU
ADJUSTMENTS
INFO
BACK
8
SMART SELECTOR WITH LCD - USER MANUAL
RED OPENING ON/OFF
PIN
DISPLAY
HOUR
VISITS
USR CYCLES
NO DATA
BACK
CLOCK
DATE
TIME
BACK
LANGUAGE
CATALAN
SPANISH
ENGLISH
FRENCH
BACK
COUNTERS
CYCLES RESET USER
RESET VISITS
BACK
CONTRAST [0-15]
BACK
INSTALLATION
MAINTENANCE
TOTAL CYCLES
MAINT CYCLES
SELECTOR VERSION
DOOR VERSION
BACK