Technical Data - Rothenberger ROWELD D 4/15 Aero Instrucciones De Uso

Fault No.
9
10
11
13
14
15
16
17
18
19
20
22
23
1)
Consult ROTHENBERGER Werkzeuge GmbH
8

Technical data

Welding materials ................................... PP, PE, PVDF
Welding rate, approx. .............................. Ø 3 mm: 1,1 kg/h PP/PE
Welding rod ............................................ Welding rod Ø 3 and 4 mm
Application range .................................... Wall thicknesses 4-15 mm and film/sheeting welds
Weight .................................................... 5,5 kg
Drive ....................................................... 230 V or 120 V AC with speed control
Extruder heating system ......................... 400 W / 120 V
Air preheater ........................................... 2300 W / 230 V , 1750 W / 120 V
Air supply ................................................ Integrated air supply
Air rate .................................................... ------------
Protection class ...................................... I
Possible causes
Melt temperature below start interlock
temperature
Preheat time for hot air too short
Preheat time for melt too short
Air supply not constant
Wrong rated voltage
Extension cable heats up
Extruder nozzle plugged with foreign
matter
Drive unit defective
Electronic control defective
Controller programming error
Welding rod feed
Hot air unit defective
No mains voltage
Remedies
Allow hand extruder to heat up
Allow hand extruder to heat up
Allow hand extruder to heat up
1)
Rated voltage > permissible voltage
Check mains voltage
Rated voltage < permissible voltage
Check mains voltage
Unroll cable reel
Check cable cross-section (see also
section "Safety")
Clean extruder.
Extruder nozzle – left-hand thread
1)
1)
1)
Remove welding rod
Observe instructions in section
"Maintenance"!
Observe instructions for operation!
1)
Check voltage supply
Ø 4 mm: 1,8 kg/h PP/PE
ENGLISH
1)
29