BlueWeld BCP 28 LCD Manual De Instrucciones página 7

-
safety chapter).
-
welding operations.
4.3.4 Thermal protection switch (AL1)
thermal threshold.
on.
the allowed threshold (the AL1 icon will switch off and the "START" icon will switch on).
4.3.5 Compressed air safety switch (AL6 - PCP mod. only)
4.3.6 Overvoltage and undervoltage trip switch (AL3 and AL4).
(welding inhibited).
5. INSTALLATION
prescribed (e.g. on arms or electrodes).
5.3 POSITION
Maximum load
electrode axis) is 35 Kg. (35daN).
switches indicated below:
recommend connecting the spot welder to interface points of the main power
(FIG. E)
5.4.2 Connecting the power supply cable to the spot-welder (FIG. F)
(FIG. F1, F2).
5.4.3 Plug and socket
are given in the paragraph "OTHER TECHNICAL DATA" and/or in TAB. 1.
(class I) safety system provided by the manufacturer causing serious risks to
5.5 PNEUMATIC CONNECTION (FIG. G) (PCP mod. only)
5.6 CONNECTING THE COOLING CIRCUIT (FIG. H)
switched off (DISCONNECTED).
the electrode holders are centred.
(see technical data).
to be welded and to the diameter of the electrode tip.
starts welding.
contact with live or moving parts.
6.2 ADJUSTING THE PARAMETERS
The parameters determining the diameter (section) and the mechanical resistance of
spot welding are:
These are:
- 7 -