Cancelling A Programme - BlueWeld BCP 28 LCD Manual De Instrucciones

- length of arms (see technical data).
6.3 PROCEDURE
mode (all the welding parameters are enabled).
- Set the welding parameters.
- Position the sheet metal to be spot-welded on the electrode.
obtain:
spot weld.
two sheets.
6.4.1 Saving the spot welding parameters
in the paragraph below.
6.4.2 Modifying the spot-welding parameters on a customised programme
6.4.3 Retrieving a programme

6.4.4 Cancelling a programme

parameters.
NOTE: the parameters of the "DEF" or free programme cannot be reset: pressing the
In the versions driven by pneumatic cylinder (PCP models) it is necessary to
- Replacement of the electrodes and the arms.
TECHNICIANS.
SUPPLIES.
with moving parts.
At the same time:
connections.
/ wires are tight and that there are no signs of oxidation or overheating.
are no signs of oxidation or overheating.
Use all the original washers and screws when closing the casing.
excessive voltage drop etc.).
welding icon ON for the set time.
- 8 -