Publicidad
Idiomas disponibles
Idiomas disponibles
Disconnect the trailer connector
and install the T-harness
between the trailer connector and
the factory harness. Connect the
two-pin connector of the T-
harness to the amplifier harness.
Fig 11&12
Connect the two-pin amplifier harness connector to the two-pin T-harness connector
Remove lights (if equipped) from factory cover panels and install into the speaker baffle.
Note: Lights are keyed and can only be installed one way. Do not force light into
speaker baffle incorrectly.
Lay a towel on the tailgate step to avoid scratching the face of the speaker baffle and connect the speaker
wires to the speakers. Next, install the foam strips as shown in Fig 13. Use the measurements shown to
place the shorter sections, and then place the longer sections between the short sections and against the
edge of the speaker baffle.
Note: There are two different size connectors. Make sure the large connector is
connected to the large speaker terminal and the small connector is connected
to the small speaker terminal.
Note: Make sure the speaker terminals are properly inserted into connectors. It is
possible for the speaker terminal to be inadvertently inserted between the
metal connector and the plastic insulator.
Note: The foam strips provided are longer than necessary and need to be cut to fit.
1.5"
Place long sections between the short sections.
1"
1"
Fig 11
Fig 12
1.5"
Fig 13
5
Publicidad
