Publicidad
Idiomas disponibles
Idiomas disponibles
Connect the controller to the amplifier and secure by turning locking ring clockwise until finger tight.
Secure with wire ties Fig 14
Connect the 1/8-inch jack to the amplifier. Secure with wire ties Fig 14
Connect the USB cable to the amplifier and secure to the metal tab with supplied wire tie. Fig 15
Secure extra controller cable with wire ties.
Note: Trim wire tie ends. Make certain there are no loose ends of wire ties or wires
that can contact the plastic housing or the tailgate in order to prevent buzzes or
rattles from vibration.
Reconnect the negative battery cable.
Install speaker baffle over the step hinges and
loosely install the six supplied Torx-head bolts.
The speaker baffle must be rotated into position
starting with the top edge. It may be helpful to
have assistance in pressing the top edges of the
baffle toward the tailgate in order to get the small
retention brackets under the sheet metal. Once all
Torx-head bolts are installed, tighten while
pushing up on the speaker baffle. Fig. 16
Note: Scan the QR code for video
of baffle installation.
Test function of speaker system. Refer to Bluetooth Controller Manual.
Fig 14
Fig 15
six
Fig 16
6
Publicidad
