Functional Description - Makita 2702 Manual De Instrucciones

If during operation there is any tendency for the table saw
to tip over, slide or move, the work bench or table saw
stand should be secured to the floor.
NOTE:
• Table saw stand
Models 2702X1
equipped with a table saw stand.
Storing accessories
1
1
The miter gauge and wrenches can be stored on the left
side of the base and the rip fence can be stored at the
rear of the base.

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Adjusting the depth of cut
1
The depth of cut may be adjusted by turning the handle.
Turn the handle clockwise to raise the blade or counter-
clockwise to lower it.
and 2703X1 are standard-
006858
1. Miter gauge
006859
1. Rip fence
006860
1. Handle
NOTE:
• Use a shallow depth setting when cutting thin
materials in order to obtain a cleaner cut.
Adjusting the bevel angle
1
2
Loosen the lock lever counterclockwise and turn the
handwheel until the desired angle (0° - 45°) is obtained.
The bevel angle is indicated by the arrow pointer.
After obtaining the desired angle, tighten the lock lever
clockwise to secure the adjustment.
CAUTION:
• After adjusting the bevel angle, be sure to tighten
the lock lever securely.
Adjusting positive stops
1
(A)
90
45
45
90
(B)
The tool is equipped with positive stops at 90° and 45° to
the table surface. To check and adjust the positive stops,
proceed as follows:
Move the handwheel as far as possible by turning it.
Place a triangular rule on the table and check to see if
the blade is at 90° or 45° to the table surface. If the blade
is at an angle shown in Fig. A, turn the adjusting screws
clockwise; if it is at an angle shown in Fig. B, turn the
5
006861
1. Lock lever
2. Handwheel
3. Arrow pointer
3
006862
1. 90° adjusting
screw
2. 45° adjusting
screw
2
006157