mysoda RUBY Manual De Instrucciones página 5

HOW TO MAKE SPARKLING WATER
1. Fill the water bottle with cold
water up to the fill line.
3. Push the carbonation button
2–3 times, stop when you hear a
hissing sound.
5. Release the bottle by turning it
by one quarter clockwise.
NOTE: Only use compatible CO2 cylinders and Mysoda water bottles. Never carbonate if the bottle is empty, not filled up to the fill
line or if water is above the fill line.
CARE AND CLEANING OF YOUR DEVICE
SPARKLING WATER MAKER:
To clean your sparkling water maker,
wipe with a damp cloth. Do not immerse
the device in water. Do not use any
solvents or abrasive cleaners, since this
could damage the surface.
WATER BOTTLE:
Rinse the water bottle with clean water
after each use. Wash the bottle by
hand with hand warm water and hand
dishwashing detergent. Rinse well. Wipe
the outside with a soft cloth to dry.
2. To insert the water bottle, make
sure that the device is in a fully upright
position and the bottle quick-lock is
angled forward. Then insert the bottle
1
to the quick-lock and turn one quarter
ant-clockwise to lock. Push the
bottle towards the device to a vertical
position.
2
4. Pull the bottle towards yourself to
release pressure inside the bottle.
6. Enjoy your carbonated water or add
desired flavour.
CO2 CYLINDER:
A used CO2 cylinder can be refilled by
your Mysoda dealer. Return the empty
cylinder so that you only pay for the
gas refill.
ENGLISH 5