Mx Onda MX-AS2050 Manual De Instrucciones página 53

Attention: Before cleaning or manipulating the vacuum cleaner, make sure
it is unplugged from the mains.
Dust deposit cleaning
 Unplug the vacuum cleaner from the mains.
 Open the tank lid and empty the tank.
 Once the tank has been emptied, remove the cyclone
filter and then the HEPA filter.
 Wash the cyclonic filter and the HEPA filter with plenty
of water. Never use abrasive products or products that
contain solvents. Then dry the cyclonic filter with a dry
cloth. The HEPA filter must be allowed to dry by itself,
do not use a hair dryer or heater as this will damage it.
 Once the filters are clean and completely dry, place
them inside the tank.
Post-Motor Filter Cleaning
At the back of the body of the vacuum cleaner is the post-motor filter, whose
function is to retain any particles that may come out of the tank. To clean it,
remove the back cover of the vacuum cleaner, remove the filter, then wash it
with plenty of water, do not use abrasive products or products that contain
solvents, then let it dry on its own. Once dry, place it in its compartment and put
the back cover back on.
Attention: Never connect the vacuum cleaner to the mains without all filters
being correctly put in place.
Vacuum cleaning, maintenance and storage

Check the condition of the parts and accessories (tubes, nozzles, filters,
etc.) with some frequency, if necessary replace them.

Clean the plastic surface with a slightly damp cloth. Never use abrasive or
solvent-containing products and do not immerse the vacuum in water or
any other liquid.

To store the vacuum cleaner you can use the wall bracket.
THERMAL PROTECTOR
When the tank is full, the clogged filters or an accessory is clogged (extension
tube, nozzle, etc.), it will hinder the passage of air if a prolonged time elapses
(without solving the cause that caused the obstruction) and with the vacuum
cleaner On, the vacuum motor will get too hot.