Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL DATA
Working width: max. 300 mm (12")
Bending thickness: max. 2.5 mm
Bending angle: 90°
Dimensions: 350 x 60 x 600 mm
Weight: 10 kg
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This product is clamped into an existing vice (vice not included in the scope of delivery) and is used
for bending of sheet metal made of steel, copper, brass, aluminum, it is easy to use because the high-
quality bending cheek is operated by operating lever. The product is used, for example, in
metalworking, vehicle bodywork and vehicle workshops.
SAFETY INFORMATIONS
• Operate the tool using common sense.
• Keep children and unauthorised persons out of the work area.
• Do not allow children to play with this product or its packaging.
• Make sure that the work area is sufficiently illuminated.
• Keep the work area clean, organised, dry and free from other materials.
• Do not carry out any modifications on the tool.
• Before use, check the tool for damage. If a part is damaged, use the tool again only after all
damaged parts have been repaired by an authorised specialist. Do not use the tool if it is
damaged.
• Do not reach into the bending device and always secure a firm footing so that you can keep
your balance at all times.
• Store the product in a dry and safe place, out of the reach of children.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Mini Bending Machine | 300 mm
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 74245
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
