Starlyf HH18-T03 Manual De Instrucciones página 7

the device(!), but contact our customer
service department.
• Before using the device, remove all
packaging materials and any labels that
may be on the device and are used for
protection during transportation or for
advertising.
Assembly
1. Plug the telescopic rod (2) into the
recess on the top of the motor unit (4).
2. Assmble the wings of hanger with
screw ,Place the hanger (1) onto the
telescopic rod (2). When you do this,
make sure that the slight bend in the
hanger (1) points forwards.
3. Attach the nylon balloon:
– Pull it over the hanger (1). When you
do this, make sure that the side with the
hole line points forwards.
– Put the neck at the top over the collar
section (9) on the hanger (1).
– Pull the large elastic cord at the
bottom over the mounting flange (7).
The device is disassembled in the re-
verse order.
CAUTION!
Use
■ Only place the device on a stable,
flat, moisture-resistant and heat-resis-
tant surface.
■ Caution! Hot surface! The motor unit
/ telescopic rod will become hot during
use. You should therefore not touch it
during or shortly after use.
■ It is essential that you follow the care
labels for the textiles to be dried!
■ Never cover up the ventilation slots
and do not insert any objects into them.
A. Set the height you want. To do this,
open the screw (8), pull out the telescopic
rod (2) and then close the screw (8) again.
B. If you have not already done so, pull
on the nylon balloon (see the "Before
Initial Use" chapter, "Assembly" sec-
tion).
The nylon balloon should sit im-
mediately below the mounting
flange (7) so that it can fully inflate.
B. Pull the garment which is to be pres-
sed over the nylon balloon and the han-
ger (1) and do up the buttons if neces-
sary. Make sure that
– the collar is fitted over the collar sec-
tion (9) on the hanger (1),
– any button strip is over the hole line
on the nylon balloon,
– the arms of the nylon balloon fit pro-
perly in the sleeves of the garment and
are not twisted or scrunched up,
– all buttons on the garment (including
on the sleeves) are done up.
4.
plug into an easily accessible socket.
5. Turn the timer (6) clockwise and set it
to the length of time you want.
6. Once the nylon balloon has inflated,
straighten out the garment and smooth
it down again.
7. When the set time elapses, the de-
vice switches off automatically. The
drying / press- ing process can be inte-
rrupted at any time by turning the timer
(6) to the starting position.
8. Remove the garment from the nylon
balloon and hanger (1).
9. Pull the mains plug out of the plug
socket and allow the device to cool
down completely.
Tips
• The device is intended primarily for
machine-spun laundry! If hand-washed
or non- machine-spun laundry is to be
pressed, first allow it to dry out a little
first.
• The drying / pressing process takes
around 10 minutes for a spun-dried
shirt. However, the length of time can
vary depending on the material and
thickness of the material. We recom-
mend that you start with a shorter time
and extend it if necessary.
• The nylon balloon can be enlarged or
reduced in size with the aid of the zip
fasten- ers. For smaller sizes, the zip
fasteners should be closed. For larger
sizes, the zip fasteners should be ope-
ned on both sides.
• Wide-apart buttons may result in
the button strip crimping slightly during
Insert the mains
7