Descargar Imprimir esta página

Genie 110AFX Manual Del Usuario página 9

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
Manual Feed Process:
1. Shred paper: insert up to 10 sheets straight into the manual feed entry.
2. Shred credit card: insert 1 card at a time into the middle of the paper feed entry.
Auto Feed Process:
1. Open the auto feed flap and Insert up to 100 sheets of paper into the auto feed tray and close the
paper guide flap. Once you insert papers into the auto feed tray, it will start shredding each sheet
automatically.
Please Note:
- Only paper should be used in the auto feed tray. Credit cards should be shred through the manual
paper feed slot.
- Do not insert additional paper into the auto feed tray when it is already in use.
- Do not insert folded paper as it may cause the unit to jam.
2. It will take approximately 9 minutes to shred 100 sheets on auto feed mode.
3. After shredding, please close the auto feed flap back the machine in order to avoid the flap gets broken.
For the safety concern, always Power Off the shredder and unplug the unit when it is unattended or not in
use.
BIN FULL LED / DOOR OPEN Indicator:
The Yellow Bin Full LED indicator will illuminate when waste bin is full or the basket is not inserted.
1. Turn the unit OFF by sliding to the Power Off position.
2. Remove the bin and either dispose of the paper shreds or compress the shreds down.
3. Re-insert the bin into the housing.
4. Slide the power switch to Auto On to resume normal operation.
OVERHEAT LED Indicator:
The Red Overheat indicator will illuminate when the motor temperature is high.
This shredder is equipped with a temperature sensor device that protects the motor from heat
damage. If the device senses the motor is too hot, it will automatically turn off the shredder and
the red Overheat LED indicator will illuminate. This is normal. If this happens, you shredder will
need approximately 60 minutes to cool. Once the Overhead LED indicator is no longer illuminated, you
can continue shredding as normal.
OVERLOAD Protection:
If too much paper is inserted into either the manual feed or auto feed the unit will automatically stop
shredding. When this occurs, slide the switch to Manual Reverse to dislodge the jammed paper. Remove
the paper, recount the pages, and continue with no more than the maximum stated capacity.
Shredder capacity:
GENIE 110 AFX will shred up to 10 sheets of A4 size 80g/sqm paper for regular throat (front slot), and
auto-feeding (flip top) for shred up to 100 sheets of A4 size 80g/sqm paper.
When shredding small material like envelopes or receipts, insert them through the front slot..
9

Publicidad

loading