Publicidad
Idiomas disponibles
Idiomas disponibles
5450100-Schrauber-man
original spare parts. This way it is
ensured that the appliance remains
safe to use.
6 – Safety instructions
relating specifically to
the equipment
• Use the appliance, the charger and
the attachments, only for their
intended applications!
• Before laying the stick screwdriver
aside, ensure that all moving parts
have come to a standstill.
• Avoid frequent blocking when drilling,
tightening or loosening screws.
• Connect the charger only to a 230 V
AC power supply.
• Charge the screwdriver battery only
with the charger supplied.
• Protect the charger and the
screwdriver from contact with
moisture. Never immerse in water!
• Do not use the charger in the open air.
• To avoid damage to the batteries,
never expose them to temperatures of
over 40 °C.
CAUTION! Do not short-circuit
the contacts of the battery or
charger.
• When charging, ensure that the
device is correctly connected („+/–").
• Do not attempt to burn the battery.
• The connection cord cannot be
replaced. In case of damage, dispose
of the device in the correct manner. In
11.10.2005 10:34 Uhr
Seite 37
case of damage, dispose of the
device in the correct manner.
7 – Installation and setting
Charging
The screwdriver battery is not fully
charged by the manufacturer. Before
using it for the first time, charge it for
5 hours. To do this, insert the charging
plug (5) into the socket (4) and connect
the charger (6) to the power supply. The
control LED (2) lights up.
CAUTION! Do not exceed the
maximum charging time of
5 hours as this causes dangerous
overheating.
RECOMMENDATION: Connect
the charger to a time switch.
Connect the charger to a time switch.
8 – Operation
Manual operation
When switched off, the drive
AUTO
shaft is automatically locked.
BLOC
In this state it can be used
manually for over-tight screws. Through
the hinge (7), the grip (8) of the
screwdriver can be set at an angle for
better leverage.
9 – Mode of operation
Insert bits of 50 mm length and over up
to the stop in the bit holder (3). With
normal 1" bits and sockets, used an
additional bit holder. Before switching
the device on, press the bit firmly onto
the screw and switch the device on in
the desired direction of rotation (1).
37
Publicidad
