Aigostar Steel Blue 31HGB Instrucciones página 4

NOTE : For the best steam quality, do not use more than three successive
bursts each time. Several pumping actions are needed to start this
function.
Excessive use of this feature will cause the iron to cool , ensure that
the pilot light is out, before operating the shot of steam control
Cleaning
1.Disconnect the appliance from the mains , before cleaning.
2.Do not use solvents or abrasive products to clean the iron , clean with a damp
cloth.
ANTI-DRIP
With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the point
where no more steam comes out, but rather drops of boiling water that can leave
marks or stains. In these cases, the Anti-drip system automatically activates to
prevent vaporization, so that you can iron the most delicate fabrics without risk of
spoiling or staining them.
Defects and repairs
Do not attempt to replace a defective mains lead .The appliance has to be
returned to an authorized service centre for repair.
Faults-reasons and solutions
Iron emits an odor or smoke
Iron gives off an odor when turned on for the first time. Oils used during
manufacture need to be burnt off allow ten minutes for odor to disappear.
Iron does not heat
The iron should be plugged into a 230 Volt , AC electrical outlet only. The
temperature dial must be set at the desired temperature.
Iron does not steam
The water tank many be empty. Turn the steam valve to "0" and add
water .Allow the iron to heat, and then set the steam dial to the steam setting.
Burst of steam feature does not work
The water tank must be at least 1/4 full .Temperature must be set to steam
position. Iron should be in the horizontal position. Prime pump briefly. Allow a
short pause between shots. Be sure to fully depress the burst of steam button.
Spry mist feature does not work
The water tank must be at least 1/4 full. Fill the iron as described in the section
"how to fill the water tank".
Iron is leaking
The variable steam dial must be set on" ",until the iron is hot . The temperature
setting is too low to produce steam. Shot of steam used too much, allow iron to
re-heat.
Warranty: 2 Years
4