Facom DF.81 Guía De Instrucciones página 4

• Observe the pressure rating provided by the manufacturer.
• Designed for use with DOT 3, DOT 4 and DOT 5.1 brake fluids only. NO LHM.
• Minimum level of required DOT : 1liter.
• Brake fl uid is corrosive and may damage the paint and bodywork of your vehicle.
• The vehicle must be on a fl at surface, a platform or rest on its wheels.
• Check the condition of the brake lines and change them if required.
• When bleeding brakes under pressure, apply manufacturer instructions scrupulously.
• After bleeding the circuit, check the brakes operate properly.
• Do not use used brake fl uid or new fl uid stored in a non-closed can.
• Clean the fi lter approximately every 3 months. (Filter reference: DF.80/100-02).
• Air present in the braking circuit may cause partial or total loss of braking, and cause a severe or lethal accident.
• Never use the brake system bleeder in a horizontal position.
• The DOT tank is integrated into the body of the brake system bleeder. DO NOT DRILL as there is a risk the liquid will leak out.
In case of necessary emergency stop, press the Off button, then the depressurize button.
Pressure drop on the pressure gauge Leak
1
NU-DF.81_0417.indd 4
EN. Technical specifications - Safety instructions
Weight in operating order (tank full) : 25kg
Housing : HDPE
Tank capacity : 10l
Power supply cable length : 4m
ATTENTION
+
STOP
2 2 2
2L MINI
Use
OEM
3 3 3
4
+
OK
OFF
18/04/2017 14:09:54