Maintenance and general troubleshooting
Inspection of handlebar and front & rear wheel
•
Move the BirdBike up, down, front, back, left and right to
check whether the handlebars and the axle nuts of the
front and rear wheels are tightened properly, whether the
handlebars are tightened properly, and whether there is
any abnormal rubbing or damage happening between
parts.
•
Push the vehicle back and forth to check whether the
front and rear wheels rotate smoothly and without any
abnormal noise or rubbing.
•
Carefully check the entire vehicle before riding and if you
find any issues, please contact a professional for repair or
contact Bird support for help.
Inspection of power circuit and lighting circuit
•
Turn on the power, operate the lighting switch, check
whether the headlights and taillights are on, and if they are
at normal levels.
•
Check for any damage with the lighting system.
•
Check whether the power cables on the BirdBike are
connected and are operating safely as intended as well as
whether all connectors are functioning properly.
Inspection of front and rear brakes
•
Adjustment of the brake lever: Pinch the front and rear
brake levers, and confirm whether the brakes are working
when the distance between the brake lever and the
handlebar is 13mm.
•
Adjustment method of the front and rear brakes: The
distance between the brake and the brake lever is
specified to be between 10-20mm.
•
When the brake is in a tightly gripped state, the brake pad
and the brake disc should be contacting evenly.
•
The brake pads and brake discs should be replaced at the
same time (the adjustment of the rear wheel brake is the
same as that of the front wheel brake).
Battery installation status
•
Confirm that the battery is in a fixed state, connected, and
operating properly.
Battery Pack Maintenance
•
Do not store or charge the battery at temperatures
outside of the stated limits (see specifications). Do
not puncture the battery. Refer to your local laws and
regulations regarding battery recycling and/or disposal.
2 1