Perel VTLLAMP16 Manual Del Usuario página 3

•
Do not use this device in the immediate surroundings of a bath, a shower or a
swimming pool.
•
There are no user-serviceable parts inside the device. Refer to an authorized dealer
for service and/or spare parts.
•
For non-replaceable light sources:
The light source of this luminaire is not replaceable; when the light source reaches
its end of life, the whole luminaire shall be replaced.
•
Do not stare directly at the light source, as this may cause
o
o
o
•
Keep away from excessive heat and direct sunlight.
•
The housing might heat up during usage. Keep minimum distances around the
device for sufficient ventilation. Place the device on a flat, heat-resistant surface. Do
not place the device on carpets, fabrics...
•
Where the mains plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
•
If the external flexible cable or cord of this luminaire is damaged, it shall be
replaced by a special cord or cord exclusively available from the manufacturer or his
service agent.
•
Never leave the magnifying lens unattended where direct sunlight may pass through
it: this creates a fire hazard. Close the lens cover after use.
3. General Guidelines
•
Refer to the Velleman
manual.
•
All modifications of the device are forbidden for safety reasons. Damage caused by
user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects or
problems.
•
Nor Velleman Group nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...) arising
from the possession, use or failure of this product.
•
Keep this manual for future reference.
4. Operation
•
Clip the lamp onto a flat, horizontal and non-slippery surface.
•
Connect to the mains and switch on.
•
Switch off and disconnect from the mains after use.
3500 K: press the black arrow ( ) until the cold white LEDs are switched off, press
the red arrow ( ) until the warm white LEDs are fully switched on.
6500 K: press the red arrow ( ) until the warm white LEDs are switched off, press
the black arrow ( ) until the cold white LEDs are fully switched on.
V. 05 – 21/12/2022
epileptic seizure in sensitive people
temporarily loss of sight (flash blindness)
permanent (irreversible) eye damage.
®
Service and Quality Warranty on the last pages of this
VTLLAMP16
3 ©Velleman Group nv