Setting The Transmission Frequency; Setting The Frequency Manually; Selecting A Frequency From A Group - Monacor International JTS UF-20S/5 Manual De Instrucciones

3) The antenna inputs are factory-set to supply
a 12 V operating voltage for antenna am-
plifiers (e g UB-900I) If no antenna amplifier
is used, deactivate the 12 V operating voltage
via the menu item
Antenna Power
ON
OFF
4) Via the menu item
name can be entered (10 characters max )
which appears on the display (e g UF-20
as shown in fig 1) When multiple pairs of
microphones / receivers are used, this will
make it easier to distinguish between the
pairs and to identify them After the menu
item
User Name
first character position is selected:
User Name
U F-20
Char:1/10
Turn the knob PUSH / CONTROL to select
the desired character Press the knob to go
to the next character position Press the but-
ton SETUP to save the name The main menu
reappears
5) For a reset to the factory settings, select the
menu item
e. Reset
warning the user that resetting will erase any
data stored:
This will erase all data
from receiver's Internal
Storage
Press 2 Sec to Reset
S
To exit, press the button EXIT; to reset, keep
the button SETUP pressed for 2 seconds until
appears
Erasing...
3.5 Setting the transmission frequency
Before switching on the corresponding wireless
microphone (JSS-20 / 5) or the corresponding
pocket transmitter (UF-20TB / 5), set the receiver
to an interference-free transmission frequency
There are three methods to do this:
1 The transmission frequency can be ad-
justed manually between 530 000 MHz and
605 000 MHz (chapter 3 5 1)
2 For operating multiple audio transmission
systems at the same time (chapter 3 5 2),
there are 15 groups with up to 63 channels
b. Antenna Power
Fig. 8
, a device
c. User Name
has been called up, the
Fig. 9
A message appears
Fig. 10
in each group (refer to the table starting on
page 46) In ideal conditions, all channels
from a group can be used for audio transmis-
sion at the same time
:
The scan function can be used to deter-
mine the channels being used for transmission
by other systems (chapter 3 5 3) These chan-
nels will be skipped during channel selection
3 Preferred frequencies can also be saved to
six user-defined frequency groups (chap-
ter 3 5 4), e g when operating multiple audio
transmission systems in varying locations

3.5.1 Setting the frequency manually

1) Call up the frequency setting via the menu
item
1. Frequency
Setup Frequency
532.625MHz
G:1 CH:1
2) Turn the knob PUSH / CONTROL to set the
frequency in steps of 1 MHz
3) For fine adjustment in steps of 0 025 MHz,
turn the knob so that the digits after the deci-
mal point are highlighted Then turn the knob
If the frequency is identical to the frequency of
a channel in a group, the group and channel
numbers are indicated in the lower line
4) Press the button SETUP to save the frequency
adjusted

3.5.2 Selecting a frequency from a group

The easiest way to operate multiple audio trans-
mission systems at the same time is to select
the frequencies for the systems from one of the
15 groups:
1) Call up the group and channel selections via
the menu item
Setup Group
G:14 CH:62
602.175 MHz
2) Turn the knob PUSH / CONTROL to select
the group
3) Press the knob to highlight the channel num-
ber Then turn the knob to select the channel
The corresponding transmission frequency is
indicated in the lower line
4) Press the button SETUP to save the setting
of the main menu:
Fig. 11
2. Group/Channel
Fig. 12
:
19