Publicidad
Idiomas disponibles
Idiomas disponibles
k) After turning off the device and turning off the water supply, get rid of
residual pressurized water from the device by pressing the trigger of the gun
until water stops flowing out of the spray lance.
3.3.2
Selecting the correct tip/nozzle
Depending on the model, there are different nozzles to choose from that
differ in the water jet and pressure generated:
•
•
•
•
3.3.3
Washing with a cleaning agent
ATTENTION: use only cleaning agents specifically designed for
pressure washers, taking into account that some agents may work
differently and have different densities at lower as at higher
temperatures. For details, look at the application instructions on the
packaging of the agent in question.
• Attach the black nozzle to the end of the spray lance.
• Pour the cleaning agent into the special tank (signed "SOAP" on
0
o
(red) - generates a very precise, point stream with the highest
pressure. This nozzle is for use only on very durable surfaces like
metal or concrete. Do not use on wood etc. delicate surfaces!
15
o
(yellow) / 25
o
deviation in both directions from the center of the nozzle. Use
these nozzles only on surfaces that can withstand high pressure.
40
(white) - a nozzle generating a medium-strong stream with
o
deviation of 40, suitable for use on most surfaces and for
universal use, e.g. washing a vehicle.
Soap / 84
o
(black) - a special nozzle with low pressure and a very
wide stream, dedicated to the application of various cleaning
agents, e.g. active foam. This nozzle should be used with special
agents, which are poured into a separate cleaning agent tank
(see separate description).
the cap), taking care that the hose sucking the agent after
reattaching the tank lid reaches the bottom of the tank:
HT-HPW-180
o
(green) - generating a strong flow of 15
o
/ 25
a
Publicidad
