Operation And Maintenance; Parts Description - Tristar KR-2156 Manual De Usuario

instruction manual
• Never use the appliance to vacuum matches, pointed objects, cigarettes,
butts or other glowing things. Do not use it on wet surfaces or surfaces
covered with cement or other substances which are too fine or even toxic
when inhaled. Never vacuum any kind of liquid with this appliance.
* Competent qualified repair service: after sales department of the producer or
importer or any person who is qualified, approved and competent to perform
this kind of repairs in order to avoid all danger. In any case you should return the
appliance to this repair service.

PaRTS DEScRiPTioN

1. Detachable nozzle with brush
2. Detachable nozzle for sucking liquid
3. Dust compartment
4. Dust compartment release button
5. Charging light (LED)
6. On/off slide
7. Filter
8. Charging station
8
9. Adapter
9
1 2
4
dust buster
6
5
4
7
3

oPERaTioN aND maiNTENaNcE

Remove all packaging of the device.
Check if the voltage of the appliance corresponds to the main voltage of your
home.
Vacuum cleaner rating: 7.2V DC 250mA 45W
Adaptor model: TDUB-63V09
Input: 230V~ 50Hz
Output: 9V DC 250mA
uSE
• You can install the charger to the wall by using the supplied screws and plugs.
Place the device in the charger and plug the adapter into the wall outlet. Load
the device at least 16 hours before using it for the first time.
• The charging light turns on to indicate that the device is in the charger and
the adapter into the wall outlet.
• The charging light stays lit until the device is in the charger and the adapter
into the wall outlet.
• The charging light indicates no information on the loading level of the built
batteries.
• Press the power button forward to switch the device on.
• Leave the adapter into the outlet, and place the vacuum cleaner after use
always back into the charger, even when the battery is still almost full.
This device comes with two accessories:
• A brush suction foot to vulnerable surfaces clean.
• A wiper fluid to be sucked.
When you suck liquids hold the device with the power nozzle down to an angle
of 30 degrees. The wiper blade should touch the surface to be cleaned. Don't tilt
the device to one side.
Stop collect liquid as the liquid level the designation has reached maximum
level.
Press the button next to the on/off switch to disconnect the dust container.
Empty the dust container every time the device is used to suck liquids and
make it dry after use.