SoFlow SO3 2nd GEN Manual Del Usuario página 20

4 Driving instructions
4.1 Operation
First switch on your SO3 2nd GEN/ SO3 PRO by pressing the start button for 2 seconds. You can turn off your SO3 2nd GEN/ SO3 PRO again by pressing and holding the
same button for a few seconds. If you press the start button only briefly, you will turn off the front light, which is turned on by default. By pressing the button briefly
and repeatedly, you switch the light back on.
Before starting your journey, make sure that the handlebars click into place.
First, switch on your SO3 2nd GEN/ SO3 PRO by pressing and holding the power button for 2 seconds. You start your SO3 2nd GEN/ SO3 PRO by using one leg to
accelerate yourself and the device by pushing your foot off the ground (like a conventional scooter). Now you can accelerate by pulling the throttle on the right side of
the handlebar.
You can operate the front disc brake and the electronic rear brake by using the brake lever on the left side of the handlebars. Shift your body weight slightly to the rear
to compensate for the braking effect of the brake. This allows safe and controlled braking. Always be careful when using the brake. Pull the brake lever firmly to stop
SO3 2nd GEN/ SO3 PRO completely.
4.2 Display
You will find the following information on the display:
•
Light
•
Speed
•
Bluethooth
•
km absolut
copyright by www.soflow.com
18