Publicidad
Idiomas disponibles
Idiomas disponibles
Mulching
A mulch kit is available as an attachment. Mulching is a process of recirculating
grass clippings repeatedly beneath the cutting deck. The ultra-fine clippings are
then forced back into the lawn where they act as a natural fertilizer.
A mulch kit can be purchased. See the Replacement Parts & Attachments section of
this manual for more information.
Using the Deck Lift Lever
To raise the cutting deck, move the deck lift lever to the left, then place it in the
notch best suited for your application. Refer to Setting The Cutting Height earlier in
this Operation section.
MOWING
WARNING
To help avoid blade contact or a thrown object injury, keep bystanders,
helpers, children and pets at least 75 feet from the machine while it is in
operation. Stop machine if anyone enters the area.
The following information will be helpful when using the cutting deck with your
tractor:
WARNING
Plan your mowing pattern to avoid discharge of materials toward roads,
sidewalks, bystanders and the like. Also, avoid discharging material against
a wall or obstruction which may cause discharged material to ricochet back
toward the operator.
•
Do not mow at high ground speed, especially if a mulch kit or grass collector
is installed.
•
For best results it is recommended that the first two laps be cut with the
discharge thrown towards the center. After the first two laps, reverse the
direction to throw the discharge to the outside for the balance of cutting.
This will give a better appearance to the lawn.
•
Do not cut the grass too short. Short grass invites weed growth and yellows
quickly in dry weather.
•
Mowing should always be done with the engine at full throttle.
•
Under heavier conditions it may be necessary to go back over the cut area a
second time to get a clean cut.
•
Do NOT attempt to mow heavy brush and weeds and extremely tall grass.
Your tractor is designed to mow lawns, NOT clear brush.
•
Keep the blades sharp and replace the blades when worn. Refer to Cutting
Blades in the Service section of this manual for proper blade sharpening
instructions.
OPERATION
Headlights
•
The lamps are ON whenever the tractor's engine is running.
•
The lamps turn OFF when the ignition key is moved to the STOP position.
16
Publicidad
