TO ADJUST HEIGHT:
There are 2 levels of height adjustment (Figures J and K).
To use seat in the lower position, keep legs folded.
To use seat in higher position, unfold and engage legs by turning seat over, releasing locking tabs, and
rotating legs out (Figure L). Push legs down into seat base, ensuring that they are fully engaged.
TO USE WITH TRAY:
Step 1: Slide tray on the front. Make sure it locks into place (Figure M) in one of the three tray
positions.
To remove, pull up the locking tabs on each side of the tray and slide off.
TO USE BOOSTER SEAT:
Step 1: Place booster seat on chair. Pass the bottom chair straps under base of chair and secure
buckle. Pull and tighten chair strap to ensure a snug fit (Figure N).
Step 2: Pass rear chair strap around back of chair and secure buckle (Figure O). Pull and tighten chair
strap to ensure a snug fit.
TO FOLD/STORE/TRAVEL:
Step 1: Release locking tab on rear of seat (circled) while pulling up on seat back (Figure P).
Step 2: Rotate seat up, forward and down.
Step 3: Fold arms inward (Figure Q).
Step 4: Turn seat over, pull legs up and fold inwards (Figures R and S).
TO CLEAN:
Wipe with warm, soapy water, rinse, and dry with a clean cloth.
Seat pad - refer to care label.