BEA WM12-156C Instrucciones Adicionales página 13

Device-specific additional instructions for nailer
4 Filling the magazine
Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Press the latch button 1 and push the magazine cover 2 to the
•
rear. Insert the shaft nails into the magazine 3 with the red side
facing upwards. Then push the magazine cover 2 forward.
5 Adjusting the magazine
Disassemble .screw 1.
•
Remove stop 2 and magazine bottom 3.
•
Insert magazine bottom 3 according to the picture below.
•
Assemble stop 2 and screw 1 again.
•
6 EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
WM12-156C
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 13