ADURO 1.1 Serie Manual De Usuario página 34

Applies to Aduro 9.4:
Aduro 9.4 must be mounted onto brick chimneys including insulated chimney elements. The stove cannot be
mounted directly to a brick chimney without insulated chimney elements or directly onto insulated chimney
elements as shown below:
2.4 Attachment / hanging of Aduro 9.4
Aduro 9.4 must be installed on a non-flammable wall. The stove is being delivered
with a wall bracket which must be properly fastened to the wall before mounting
the stove (find instructions for mounting the bracket at the back of this user
manual). You may consult your normal supplier of building materials about
suitable attachment materials for the stove/wall before the mounting. ONLY USE
FIXING MATERIALS WHICH CANNOT MELT. If you have any doubts about the
requirements, please consult your chimney sweep who will inspect the stove.
When the wall fittings are mounted and fastened correctly, the stove can be
pushed into place. Thereafter, the stove must be fastened to the wall fittings with
a screw under the bottom. The stove may also be adjusted at the top of the wall
fittings (see illustration).
The lower edge of the stove must be minimum 20.6 cm above the floor.
2.5 Mounting of soapstone on Aduro 1.1SK
Aduro 1.1SK is mounted with a stone cover. To avoid damages, it is important to follow the instructions
below when mounting the stone cover.
The top stone lies on top of the wood burning stove at delivery and is lifted off before placing the stove. In
the drawer lies 6 side stones, 12 dowels, and 6 metal brackets, which should also be removed before placing
the stove.
When the stove is placed at its final position, the stone cover can be mounted. Please follow the instructions
below. NB! Mounting of the smoke outlet at the back of the stove should be done before mounting the stone
cover.
34