Cleaning And Maintenance; Cleaning The Heating Element; Replacing The Fuse - EuroLite N-110 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The stand-by lamp of the remote control lights up. After a warm-up time the stand-by lamp turns off and the
device is ready for operation. While pressing the remote control button, the smoke emission starts and the
control lamp lights up again. If the remote control button is released before the machine stops emitting fog,
then the lamp will be off. If the remote control button is released after the machine stops emitting fog, then
the lamp will be on continuously. In either case, upon reaching a certain temperature the machine will begin
reheating and the stand-by lamp of the remote control lights up (or remains lit). The temperature is regulated
by a high quality thermostat. This process guarantees an appropriate vaporization temperature and the best
smoke emission possible. When the stand-by lamp turns off, then the device is ready for operation again.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
Clean the escape nozzle frequently from smoke fluid residues.

Cleaning the heating element

The heating element should regularly be cleaned every 30 operational hours in order to avoid clogging. Use
smoke machine cleaner available at your dealer.
Procedure:
Fill cleaner into empty tank. Run the machine several times in a well-ventilated room only. The number of
repititions depends on the pollution level of the vaporizing elements. After use clean all remaining cleaner
and rinse the tank thoroughly.
The EUROLITE smoke fluids we recommend are non-hazardous to the environment and can be disposed of
via the sewage system.
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device will be damaged, it has to be replaced by a special power supply
cable available at your dealer.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
18/33
00026694.DOC, Version 2.0

Publicidad

Tabla de contenido
loading

Tabla de contenido