Publicidad
Assembly
Battery Charging (Accessory) (see figure A)
Note: The battery is supplied partially charged. To ensure full capacity of
the battery, completely charge the battery in the battery charger before
using your power tool for the first time.
The lithium ion battery can be charged at any time without reducing its serv-
ice life. Interrupting the charging procedure does not damage the battery.
The lithium ion battery is protected against deep discharging by the "Elec-
tronic Cell Protection (ECP)". When the battery is empty, the cordless
worklight is switched off by means of a protective circuit.
WARNING
To remove the battery 3, press the battery unlocking button 4 and pull the
battery out of the cordless worklight toward the rear. Do not exert any
force.
The battery is equipped with a NTC temperature control which allows
charging only within a temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this manner.
Observe the notes for disposal.
Operation
Starting Operation
Inserting the Battery
Use only original BTI lithium ion batteries with the voltage
listed on the nameplate of your power tool. Using other batteries
can lead to injuries and pose a fire hazard.
Insert the charged battery 3 into the handle until it can be felt to engage
and faces flush against the handle.
27.7.09 • 1 609 929 U23
Do not continue to press the On/Off switch after
the cordless worklight has been automatically
switched off. The battery can be damaged.
English | 21
Publicidad
