Beamz BWA63 Manual página 6

Increase brightness
Decrease brightness
Power off
Power on
Select red colour
Select blue colour
Select green colour
Select white colour
Automatic colour change
Automatic colour change, slow jump and gradual change
Automatic colour change, fast gradient
Automatic colour change, slow gradient
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery contacts prevents the
battery from being discharged during storage. Prior to the first operation remove the foil from the battery support on the rear side of the
remote control. Otherwise operation of the remote control is not possible.
If the range of the remote control decreases, replace the battery. For this purpose, on the rear side of the remote
control press the small bar with the groove to the right (1) and at the same time remove the battery support (2). For
operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.