Woods WAC1204G Manual De Instrucciones página 18

Operating Instructions
GB
PROBLEM CAUSE
The unit fails to start Power supply failure
up
Water-full and its icon lighting
Ambient temperature too low or low high
The room temperature is lower than the set temperature in
cooling mode or higher temperature in heating mode
Insufficient cooling There is direct sunlight
The doors and windows are open, the room is crowded or there
are other heat sources
Dirty filter
Air inlet or air outlet is clogged
High noise level The unit is being placed on an uneven surface.
The compressor does Initiation of overheat protection
not work
The remote control Too long distance
does not work
The remote control didn't aim at signal receptor on unit.
The batteries have no electricity
If you are having trouble with your air conditioner, please refer to below troubleshooting. If nothing from below
works, please contact your retailer for servicing of your Air Conditioner.
Error Codes
CH01 Room temperature sensor failure
CH02 Tube temperature sensor failure
E4 Anti-freeze protection
FL Water tank in chassis is full
18
REMEDY
Connect the unit to a live electrical socket and turn it on
Drain the water stored in the unit
It is recommended to use this unit between 8-35
Change the set temperature
Close the window curtain
Close the door and window, remove other heat sources
Clean or replace the filter mesh
Remove the obstruction
Place the unit at a flat and firm surface (may reduce noise)
Wait until the temperature decrease, the unit will re-start automatically
Get closer to the air conditioner with the remote control and point it at
the signal receiver on the unit.
Replace the batteries
Check the room temperature sensor and related circuits
Check the tube temperature sensor and related circuits
Restore the functions automatically once anti-freeze protection
is over.
Drain the condensate and re-start the unit