Displaying Imbalances In Grams / Ounces; Rounding Up/Down; Rounding Up/Down For Truck Wheels; Car Wheel Balancing - Mondolfo Ferro MT 2450 Manual De Uso

- On completion press
the new dimensions, or lower the wheel guard to perform a spin.
DISPLAYING IMBALANCES IN
The system is preset to display imbalance values in grams or ounces by keeping the
key pressed for about five seconds.

Rounding up/down for truck wheels

When the machine is switched on, the truck wheel balancing function is active and the
imbalance values are displayed in multiples of 50 grams, i.e. with rounding up or down
to the nearest multiple of 50 (or in ounces if the display in ounces mode is active).
In this condition, the first forty grams of imbalance are not displayed since a threshold
is in operation, indicated by illumination of the THR light on the display panel
.
Pressing the
imbalance values are displayed in multiples of ten grams (or in half-ounces if the
display in ounces mode is active).
Pressing the same key again sets the two display modes in alternation.
When the car wheel balancing function is selected, the imbalance values are displayed
in multiples of five grams, i.e. with rounding up or down to the nearest multiple of 5 (or
in quarters of an ounce if the display in ounces mode is active).
In this condition, the first four grams of imbalance are not displayed since a threshold
is in operation, indicated by illumination of the THR light on the display panel
.
MT 2450 operator's manual
to display the imbalance values recalculated to suit
GRAMS / OUNCES

ROUNDING UP/DOWN

key eliminates the threshold (the light goes out) and the

Car wheel balancing

GB
67