Publicidad
Idiomas disponibles
Idiomas disponibles
Visit www.hyloft.com to view our animated instruction guide
with interactive tools to walk you through the installation process step by step.
(Installation time approximately 60 minutes or less)
Before beginning the unit installation, decide where it will work best for you above the open garage
door (if room allows) or beyond the open door.
PLEASE NOTE: If installing above the open garage door: at least 17" of open space is required
between the highest point of door as measured during its upward travel and the ceiling.
Locate the ceiling joists in the area of desired installation and determine the direction in which they are
running. In order to adequately disperse the stored load, you should install not more than two HyLoft
units on any two ceiling joists. The ceiling Angle Brackets are installed parallel to the ceiling joists.
Refer to the diagram below or photos on the package for additional installation clarification.
Ceiling Joist
O
1B
Drive the sinker nail (O) halfway through the center hole (where you made the pencil
mark) and test that it is securely in the joist. If the nail is secure, then finish driving the
nail. Then PRE-DRILL two 3/16"holes for each of the brackets.
W
rench or Nut Driver to install two of the 1/4 x 2" screws(G) into each pre-drilled hole.
Now repeat this process for installation of the remaining pair of angle brackets, being
sure to install them parallel to the first set.
v.44010306
INSTALL ANGLE BRACKETS
Using Stud finder
locate Joists
24" to 36"
apart
Pencil mark
sinker nail-CHECK THAT THIS ENTERS JOIST
1A
Use Outer Holes in Support Bar (C)
as a template to mark holes on joist.
Page 3 of 15
Use a 7/16" Socket
Publicidad
