Korenix JetNet 5628G Guia De Inicio Rapido página 4

5. Mount the Switch to 19'' rack
5.1 Attach the brackets to the device by using the screws provided in the Rack Mount kit.
5.2 Mount the device in the 19' rack by using four rack-mounting screws provided by the
rack manufacturer.
5.3 When installing multiple switches, mount
them in the rack one below the other.
6. Power the unit and connect to network Cable
6.1 Connect the power supply; the terminal block is for low voltage DC input, and the AC
socket is for high voltage AC/DC input.
6.2 Connect the 10/100M Copper Port: Connect the network nodes to the switch with
2/4-pair CAT5 UTP cable. The 10/100M interfaces support auto MDI/MDIX.
Connect transmit channel to receive channel at the opposite end using LC type Fiber cable.
6.4 Connect the 100Base-FX Single or Multi mode SC type Connector. Connect transmit
channel to receive channel at the opposite end using SC type Fiber cable.
6.5 Connect the Gigabit Copper Port: Connect the network node to the JetNet 5628G/5828G
with 4-pair CAT5 UTP cable. The on board 1000Base-T ports support 10/100/1000Mbps
and auto MDI/MDIX.
6.6 Connect the Gigabit SFP transceiver of the on board SFP sockets: Plug in Gigabit SFP
type Fiber cable. The 4 On board SFP sockets support 1000Base-X Single or Multi mode
Fiber transceiver.
Note: Check if the rack environment
operating temperature range. Do not
place any equipment on top of the
switch and please properly ground it.