Description
1a Protective cap*
1b 3-day beard comb & protective cap*
2
Shaver foil
3
Cutter block
4
Twistable trimmer
4a Wide trimmer (28 mm)
4b Narrow trimmer (14 mm)
5
Charging light
6
On/off switch
7
Beard length selector*
8
Adjustable comb*
9
Special cord set (design can differ)
* not with all models
Charging
Recommended ambient temperature for charging is 5 °C to 35 °C.
The battery may not charge properly or at all under extreme low or high
temperatures. Recommended ambient temperature for shaving is 15 °C
to 35 °C. Do not expose the shaver to temperatures higher than 50 °C for
extended periods of time.
• Using the special cord set, connect the shaver to an electrical outlet with
the motor switched off.
• When charging for the first time or when the shaver is not used for a few
months, leave the shaver to charge continuously for 4 hours.
• The charging light (5) shows that the appliance is being charged. When the
battery is fully charged, the charging light turns off. Intermittent blinking
after a while indicates that the battery maintains its full capacity. This can
also happen short term when charging after the battery was completely
discharged.
• A full charge provides 30 minutes of cordless shaving time depending on
your beard growth.
• Once the shaver is completely charged, discharge the shaver through
normal use. Then recharge to full capacity. Subsequent charges will take
about 1 hour.
• Maximum battery capacity will only be reached after several charging/
discharging cycles.
• 5-minute quick charge is sufficient for a shave.
12