Publicidad
Idiomas disponibles
Idiomas disponibles
Keys
(2) Keys
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(1) 1/2" wrench
(2) 7/16" wrenches
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
•
Remove all accessible loose parts and parts cartons
from carton.
•
Remove end panels and lay side panels fl at.
•
Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
CONNECT BATTERY (See Fig. 1)
WARNING: Do not short battery ter mi nals
by allowing a wrench or any other object
to contact both terminals at the same
time. Before connecting battery, remove
metal bracelets, wristwatch bands, rings,
etc. Positive terminal must be connected
fi rst to prevent sparking from ac ci den tal
grounding.
NOTE: If this battery is put into service after month and
year indicated on label (label is located between terminals)
charge battery for minimum of one hour at 6-10 amps. (See
"BATTERY" in the Maintenance section of this manual for
charging instructions.)
UNASSEMBLED PARTS
(1) Oil Drain Tube
For Future Use
(1) Quick
Connect
ASSEMBLY
Tire pressure gauge
Utility knife
Slope Sheet
•
Determine battery location. Battery location will be
under the seat or the hood.
•
Lift seat pan or hood to raised position.
•
Remove two terminal caps and discard.
•
First connect RED battery cable to positive (+) terminal
with bolt and nut as shown. Tighten securely. Slide
Pliers
terminal cover over terminal.
•
Connect BLACK grounding cable to negative (-)
ter mi nal with remaining bolt and nut. Tighten se cure ly.
TERMINAL
COVER
POSITIVE
(RED)
CABLE
TO ADJUST SEAT (See Fig. 2)
•
Lower seat into operating position and sit in seat.
•
Slide seat until a comfortable position is reached which
allows you to reach full travel of the clutch/brake pedal.
•
Get off seat without moving its ad just ed position.
•
Raise seat and tighten adjustment knob securely.
VERTICAL SEAT ADJUSTMENT
Seat pan comes in the upper position from the factory and
can be moved to the lower position for ease of operation.
TO ADJUST
•
Remove nuts and bolts.
•
Relocate seat pan assembly to lower position.
•
Reinstall bolts and nuts, tighten to 15-20 ft. lbs.
•
Refer to "TO ADJUST SEAT" for fi nal seat adjustment.
5
Battery
(2) Hex Bolts
*Installed by Dealer
*Brush Guard Kit
NUT
LABEL
02605
Fig. 1
(2) Nut Keps
TERMINAL
CAP
BOLT
NEGATIVE
(BLACK)
CABLE
Publicidad
