Unassembled Parts; Tools Required For Assembly - Husqvarna GT54LS Manual De Operario

(1) Small
Retainer Springs
(5) Large
Retainer Springs
(1) Anti-Sway Bar
Keys
(2) Keys
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to ensure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(2) 7/16" wrenches
(1) 1/2" wrench
(1) 3/4" wrench
(1) 3/4" socket w/drive ratchet
(1) 9/16" wrench
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).

UNASSEMBLED PARTS

Mower
(2) Rear
Lift Link
Assemblies
(1) Front
Lift Link
Assembly
If Equipped
(1) 3/4 O.D.
Washers
(1) Oil Drain Tube
(1) Quick Connect
ASSEMBLY
Utility knife
Tire pressure gauge
Pliers
Flashlight
Mower Front Wheel
(1) Shoulder Bolt
(1) Wheel
(1) Small Retainer
Springs
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton.
• Remove end panels and lay side panels flat.
• Remove mower and packing materials.
• Check for any additional loose parts or cartons and
remove.
5
(1) 1-1/4 O.D.
Washer
(1) 3/8-16
Locknut
Battery
(2) Hex Bolts
(2) Nut Keps
Slope Sheet