2. Align the Paper Template's Centre Line with
the centre of your TV (if you are mounting
the Soundbar below your TV), and then fix
the Wall Mount Guide to the wall using tape.
• If you are not mounting below a TV, place
the Centre Line in the centre of the
installation area.
Centre Line
3. Use a sharp object, such as a pen or pencil, to
mark the holes' positions, and then remove
the Wall mount Guide.
4. Using an appropriately sized drill bit, drill a
hole in the wall at each marking.
• If the markings do not correspond to the
positions of studs, make sure you insert
appropriate anchors or mollies into the
holes before you insert the support
screws. If you use anchors or mollies,
make sure the holes you drill are large
enough for the anchors or mollies you
use.
450mm
450mm
CENTER LINE
5. Push a screw (not supplied) through each
Holder-Screw, and then screw each screw
firmly into a support screw hole.
6. Install the 2 Bracket-Wall Mounts in the
correct orientation on the bottom of the
Soundbar, using 2 Screws.
• When assembling, make sure the hanger
part of the Bracket-Wall Mounts are
located behind the rear of the Soundbar.
Right end of Soundbar
ENG - 28
Rear of Soundbar